top of page
Exfoliate your paint
Our process
This service takes roughly 3 hours
Price: $150
Step 1: Foam down the vehicle to pre-soak and remove the dirt and do the heavy lifting.
Step 2: While the vehicle is foamed down we will work on the wheels and remove iron deposits aka rust to keep the wheels from breaking down. Note Depending on the brake dust, might require wheel polishing to get them looking new again
Step 3: rinse the foam off to get the dirt off the vehicle and work on round two of foaming the vehicle to do our gentle contact wash.
Step 4: once done washing, while the car is still wet, we will apply our iron remover to remove rust on your vehicle and wait 5 minutes to have our chemicals do their magic. Then rinse off
Step 5: Use our clay mitts or bars to remove the "blackheads" in the paint. This gives you a fresh and clean paint that not only looks good but feel smooth
Step 6: Apply our Si02 Coating and imdedaly wash off and your vehicle is now protected for 3 months with high water repelincey
Step 7: Dry your vehicle with highly absorbent towels and hydrate. Blow out all seams and cracks of water to ensure no water is sitting behind to damage your paint.
Step 8: Apply our tire dressing and leave a beautiful matte finish not like the cheap tire shines that wear off after a day. As well as we apply our trim coating to leave a rich and supple look
Your car can look like this!
Are you ready to book?
Anchor 1
bottom of page